Instruction Manual

Table Of Contents
0458-728-9621-A
34
English
16 Troubleshooting
16.1 Troubleshooting the Cordless Product, AP Belt Bag with Connecting Cable and the Battery
16 Troubleshooting
Condition LEDs on battery
and beeps
Cause Remedy
Cordless product
does not run after
switch-on or cuts out
during operation.
1LED flashes
green.
Battery has low charge. Recharge the battery fully as described in the
instruction manual for the STIHL AL 101, 300, 500
chargers.
1 LED glows red. Battery too hot or too cold. Remove the battery.
Allow battery to cool down / warm up.
3 LEDs flash red. There is a malfunction in
the battery.
Remove the battery.
Clean the electrical contacts in the AP belt bag with
connecting cable.
Fit the battery.
Switch on the cordless product.
If 3 LEDs continue to flash red: Contact a STIHL
servicing dealer for assistance.
3 LEDs glow red. Cordless product too hot. Remove the battery.
Wait for cordless product to cool down.
4 LEDs flash red
and short beeps
sound in quick
succession.
There is a malfunction in
the battery.
Remove battery and insert it again.
Switch on the cordless product.
If 4 LEDs continue to flash red and short beeps
sound in quick succession: Do not use the battery
and contact your STIHL dealer for assistance.
No electrical contact
between cordless product
and battery.
Remove the battery.
Clean the electrical contacts in the AP belt bag with
connecting cable.
Fit the battery.
If the cordless product still does not run when
switched on or cuts out during operation: Clean
contacts of the connecting cable.
Cordless product or battery
damp.
Allow cordless product / battery to dry.