Instruction Manual

BF-MM, BK-MM
English
7
Only loosen the surface soil around
plants. Avoid going too deep as this
could damage the shallow roots of some
plants.
To avoid any damage to the cultivator or
trees, be wary not to catch the blades on
the large roots of trees.
N Working in soil improvers
The cultivator can be used for mulching
with loam, compost, leaves, other
organic material or fertilizers.
Prepare the area by removing all old
roots, the remains of large plants and
hard objects (stones etc.). Spread the
mulch evenly on the ground.
Work in the mulch with a back and forth
motion.
Finish off by leveling the area with a
rake.
N Trenching or furrowing
Walk slowly backward and pull the
cultivator to create the furrow required.
Repeat as necessary to obtain deeper
furrows.
Cleaning the rotor blades
Parts of plants, e.g. roots, can become
tightly wrapped around or between the
rotor blades during operation. To clean
the rotor blades:
– Wear gloves.
– Pull the hitch pins out of the axle.
– Pull the rotor blades off the shaft.
– Remove roots, plants and soil.
Refer to "Mounting the MultiTool" for
mounting instructions.
Cultivator spur (special accessory)
The cultivator spur simplifies control and
makes operation of the power tool less
tiring. It slows the forward motion and
reduces the effort required to hold the
power tool.
The spur breaks up the ridge between
the rotor blades when tilling hard soil.
N Use the screw and knob to mount
the cultivator spur to the right-hand
side of the flange.
N Set the spur to the required depth
and tighten it down firmly.
Only use MultiEngines supplied by
STIHL or expressly approved by STIHL
for use with the MultiTool.
This MultiTool may only be used in
combination with the STIHL MM 56
MultiEngine.
469BA020 KN
469BA003 KN
Approved MultiEngines