Instruction Manual

BG 56, BG 56 C, BG 66, BG 66 C, BG 86, BG 86 C, SH 56, SH 56 C, SH 86, SH 86 C
English
4
Transporting in a vehicle:
– Secure the machine against
overturning, damage and fuel
spillage
Refueling
Always shut off the engine before
refueling.
Do not fuel a hot engine – fuel may spill
and cause a fire.
Open the fuel cap carefully to allow any
pressure build-up in the tank to release
slowly and avoid fuel spillage.
Only refuel the machine in a well
ventilated place. If you spill fuel, wipe the
machine immediately – if fuel gets on
your clothing, change immediately.
This helps reduce the risk of unit
vibrations causing an incorrectly
tightened fuel cap to loosen or come off
and spill quantities of fuel.
Before starting
Check that your machine is properly
assembled and in good condition – refer
to appropriate chapters in the instruction
manual:
– Check the fuel system for leaks,
especially the visible parts, e. g.,
fuel cap, hose connections, manual
fuel pump (only in machines with a
manual fuel pump). In case of
leakage and damage, do not start
the engine – risk of fire! Have the
machine serviced by a dealer
before using it
– Throttle trigger must move freely
and spring back by itself to the idle
position
– Setting lever/switch must move
easily to STOP or 0
– Keep the handles dry and clean –
free from oil and dirt – this is
important for safe control of the
machine
– The blower tubes must be properly
assembled.
– Check that the spark plug boot is
secure – a loose boot may cause
sparking that could ignite
combustible fumes and cause a fire!
– Check the condition of blower wheel
and blower housing.
Wear of the blower housing (cracks,
nicks, chips) may result in an increased
risk of injury from thrown foreign objects.
If the blower housing is damaged,
consult your dealer – STIHL
recommends you contact a STIHL
servicing dealer.
Never attempt to modify the controls or
safety devices
To reduce the risk of accidents and
personal injury, do not operate your
power tool if it is not properly assembled
and in good condition.
Starting the engine
Start the engine at least 3 meters from
the fueling spot, outdoors only.
Your power tool is designed to be
operated by one person only. Do not
allow other persons in the work area –
even when starting.
Do not drop-start the power tool – start
the engine as described in the user
manual.
Place the machine on level ground only,
ensure that you have a secure footing
and hold the machine securely.
As soon as the engine starts, the
increasing air flow may eject objects
(e.g. stones).
While working
In the event of impending danger or in
an emergency, switch off the engine
immediately by moving the setting lever
/ switch to STOP or 0.
Your power tool is designed to be
operated by one person only. Do not
allow other persons in the work area.
Gasoline is extremely
flammable – keep it
away from naked flames
– do not spill any fuel – no
smoking.
Check for fuel leakage!
Never start the engine if
fuel has been spilled or is
leaking – Fatal burns may
result!
After fueling, tighten
down the screw-type fuel
cap as securely as
possible.