Owner's Manual

BG 55, BG 65, BG 85, SH 55, SH 85
English
19
General Information
The carburetor comes from the factory
with a standard setting.
This setting provides an optimum fuel-air
mixture under most operating
conditions.
Preparations
N Shut off the engine.
N Check the air filter and clean or
replace if necessary.
N Check the spark arresting screen
(not in all models, country-specific)
in the muffler and clean or replace if
necessary.
Different Standard Settings
Different carburetors are installed at the
factory. A different standard setting is
necessary for each of these carburetors.
Standard setting A
– High speed screw (H) = 3/4
– Low speed screw (L) = 1
Standard setting B
– High speed screw (H) = 3/4
– Low speed screw (L) = 3/4
N Determine the required standard
setting as follows: Turn the low
speed screw (L) carefully clockwise
as far as stop, then turn it
counterclockwise.
Is range of adjustment more than 1 turn?
N Continue with "Standard setting A"
Is range of adjustment less than 1 turn?
N Continue with "Standard setting B"
Standard setting A
N Turn high speed screw (H)
counterclockwise as far as stop (no
more than 3/4 turn).
N Turn the low speed screw (L)
carefully clockwise until it is against
its seat, then turn it back 1 full turn
Adjusting the Carburetor
295BA084 KN
295BA085 KN