Instruction Manual
Table Of Contents
- 1 Introduction
- 2 Guide to Using this Manual
- 3 Main Parts
- 4 Safety Symbols on the Products
- 5 IMPORTANT SAFETY INSTRUCTIONS
- 6 Battery Safety
- 7 Charger Safety
- 8 Maintenance, Repair and Storage
- 9 General Warnings and Instructions
- 10 Before Starting Work
- 11 Charging the Battery
- 12 LED Diagnostics
- 13 Assembling the Blower
- 14 Inserting and Removing the Battery
- 15 Switching the Blower On and Off
- 16 Checking the Controls
- 17 During Operation
- 18 After Finishing Work
- 19 Transporting the Blower and Battery
- 20 Storing the Blower, Battery and Charger
- 21 Cleaning
- 22 Inspection and Maintenance
- 23 Troubleshooting Guide
- 24 Specifications
- 25 Replacement Parts and Equipment
- 26 Disposal
- 27 Limited Warranty
- 28 Trademarks
- 29 Addresses
- 1 Introducción
- 2 Acerca de este manual de instrucciones
- 3 Componentes importantes
- 4 Símbolos de seguridad en los productos
- 5 INSTRUCCIONES IMPORTANTES DE SEGURIDAD
- 6 Seguridad de la batería
- 7 Seguridad del cargador
- 8 Mantenimiento, reparación y almacenamiento
- 9 Advertencias e instrucciones generales
- 10 Antes de empezar a trabajar
- 11 Carga de la batería
- 12 Diagnóstico de LED
- 13 Armado del soplador
- 14 Colocación y extracción de la batería.
- 15 Encendido y apagado del soplador
- 16 Revisión de los controles
- 17 Durante el funcionamiento
- 18 Después de completar el trabajo
- 19 Transporte del soplador y de la batería
- 20 Almacenamiento del soplador, la batería y el cargador
- 21 Limpieza
- 22 Inspección y mantenimiento
- 23 Guía de solución de problemas
- 24 Especificaciones
- 25 Piezas y equipos de repuesto
- 26 Eliminación
- 27 Garantía limitada
- 28 Marcas comerciales
- 29 Direcciones

0458-807-8621-A
17
English
12 LED Diagnostics
To charge the battery:
► Push the battery(2) into the charger(3) until it stops.
The LED on the charger(4) glows green when the battery
is charging.
The LEDs (1) on the battery glow green and show the
state of charge.
When the LEDs on the battery turn off, the charging
process is complete and the charger will shut itself off.
► Remove the battery from the charger and disconnect the
power supply cord from the wall outlet when charging is
complete.
A battery is not fully charged when it ships from the factory.
STIHL recommends that you fully charge the battery before
using it the first time.
Operate the charger only indoors, in dry rooms and within an
ambient temperature range of 41°F to 104°F (5°C to
40°C).
The battery heats up during operation of the blower. If a hot
battery is inserted into the charger, it may be necessary for
it to cool down before charging starts. The charging process
begins only after the battery has cooled down sufficiently.
Charging time depends on a number of factors, including
battery condition and the ambient temperature. For a
complete list of approximate charging times, see
www.stihl.com/charging-times.
11.3 Mounting the Charger on a Wall
When mounting, ensure that no electrical cables, pipes or
other service lines run in the wall behind the charger.
To mount the wall charger:
► Mount the charger indoors in a dry room near a wall outlet.
► Sink the screws into a wall stud. Use appropriate screw-in
wall anchors or other similar mounting devices if an
appropriate wall stud is not available.
► Align the charger as shown above. Mount to a wall with the
following dimensions:
– a=minimum 3.9in. (100mm)
– b(for AL101) =3.0in. (75mm)
– b(for AL300 and AL500) =4.7in. (120mm)
– c=0.2in. (4,5mm)
– d=0.4in. (9mm)
– e=0.1in. (2,5mm)
12.1 LEDs on the Battery
12.1.1 Battery Status
Four LEDs show the status of the battery. These LEDs can
glow or flash green or red.
3
2
4
1
0000-GXX-0637-A0
12 LED Diagnostics
d
a
1
2
0000-GXX-0609-A0
a
e
e
b
3