Instruction Manual
Table Of Contents
- 1 Introduction
- 2 Guide to Using this Manual
- 3 Main Parts
- 4 Safety Symbols on the Products
- 5 IMPORTANT SAFETY INSTRUCTIONS
- 6 Battery Safety
- 7 Charger Safety
- 8 Maintenance, Repair and Storage
- 9 General Warnings and Instructions
- 10 Before Starting Work
- 11 Charging the Battery
- 12 LED Diagnostics
- 13 Assembling the Blower
- 14 Inserting and Removing the Battery
- 15 Switching the Blower On and Off
- 16 Checking the Controls
- 17 During Operation
- 18 After Finishing Work
- 19 Transporting the Blower and Battery
- 20 Storing the Blower, Battery and Charger
- 21 Cleaning
- 22 Inspection and Maintenance
- 23 Troubleshooting Guide
- 24 Specifications
- 25 Replacement Parts and Equipment
- 26 Disposal
- 27 Limited Warranty
- 28 Trademarks
- 29 Addresses
- 1 Introducción
- 2 Acerca de este manual de instrucciones
- 3 Componentes importantes
- 4 Símbolos de seguridad en los productos
- 5 INSTRUCCIONES IMPORTANTES DE SEGURIDAD
- 6 Seguridad de la batería
- 7 Seguridad del cargador
- 8 Mantenimiento, reparación y almacenamiento
- 9 Advertencias e instrucciones generales
- 10 Antes de empezar a trabajar
- 11 Carga de la batería
- 12 Diagnóstico de LED
- 13 Armado del soplador
- 14 Colocación y extracción de la batería.
- 15 Encendido y apagado del soplador
- 16 Revisión de los controles
- 17 Durante el funcionamiento
- 18 Después de completar el trabajo
- 19 Transporte del soplador y de la batería
- 20 Almacenamiento del soplador, la batería y el cargador
- 21 Limpieza
- 22 Inspección y mantenimiento
- 23 Guía de solución de problemas
- 24 Especificaciones
- 25 Piezas y equipos de repuesto
- 26 Eliminación
- 27 Garantía limitada
- 28 Marcas comerciales
- 29 Direcciones

0458-807-8621-A
18
English
12 LED Diagnostics
12.1.2 Blower Status
When the battery is inserted in the blower, the same LEDs
on the battery will indicate the status of the blower.
If three LEDs glow red continuously: the blower motor is too
hot. Allow the motor to cool down.
If three LEDs flash red when you activate the trigger switch:
the blower has an electrical malfunction. Do not operate the
blower. Have it checked by an authorized STIHL servicing
dealer before use or storage.
For troubleshooting information, @ 23.
12.1.3 Charge Status
The LEDs on the battery also show the battery's state of
charge.
To determine the battery's state of charge:
► Press the button(1) on the battery.
The LEDs on the battery will glow or flash green for about
5seconds and indicate the state of charge (see
illustration).
For example:
If four green LEDs glow continuously: full charge.
If one green LED is flashing: less than 20% charge.
12.2 LED on the Charger
One LED shows the status of the charger. The LED can glow
green or flash red.
For more information, @ 23.
If one LED glows red continuously: the battery
is either too hot or too cold. Allow the battery
to warm up or cool down gradually at an
ambient temperature of about 50°F to 68°F
(10°C to 20°C).
If all 4LEDs flash red: the battery has a
malfunction and must be replaced. Do not
attempt to charge, use or store the battery.
1
0000-GXX-0629-A0
20-40%
40-60%
60-80%
80-100%
0-20%
If the LED glows green continuously: the battery
is being charged.
or
The battery is too hot or too cold for charging. To
determine, check the LEDs on the battery. If
there is one glowing red light, allow the battery to
warm up or cool down gradually at an ambient
temperature of about 50°F to 68°F (10°C to
20°C).
If the LED flashes red: there is no electric contact
between the battery and the charger. Remove
and reinsert the battery.
or
The battery has a malfunction and must be
replaced. Check the LEDs on the battery. Do not
use or charge a battery if its LEDs indicate a
malfunction.
or
The charger has a malfunction. Have it checked
by an authorized STIHL servicing dealer before
use.