Instruction Manual

BGE 61, BGE 71
English
11
BGE 71 only
Your vacuum shredder can be switched
on only when the elbow and suction tube
are properly mounted. The union nuts
activate a switch which closes the circuit
to allow the motor to be switched on.
N Disconnect the plug from the power
supply.
Mounting the Elbow
WARNING
Make sure the zipper on the catcher bag
is closed.
N Push the elbow (1) into the catcher
bag (2) as far as the mark (smaller
arrow).
N Tighten strap (3) on catcher bag
and press down the buckle tab (4).
N Line up the recesses.
N Push the elbow (5) into the blower
housing stub (6) as far as stop.
N Push the union nut (7) over the
blower housing stub (6) and turn it in
the direction of the arrow as far as
the stop. You will hear the safety
switch being activated.
Assembling the Suction Tube
N Line up the arrows on the suction
tube and extension tube. Push
together and lock in position.
Mounting the Suction Tube
N Shut off the engine.
N Press down the lock button (1) by
inserting a suitable tool through the
opening.
N Push lug (arrow) against blower
housing and hold it there.
N Rotate the intake screen (2) in the
direction of arrow as far as the stop
and lift it away.
N Line up the arrows (3).
N Push the suction tube into the intake
opening as far as the stop.
Assembling the Vacuum
Attachment
4
290BA015 KN
3
2
1
7
5
6
0000-GXX-2309-A0
295BA080 KN
2
1
0000-GXX-2310-A0
290BA009 KN