Instruction Manual

BR 200
English
14
Install the filter element.
N Fit the filter in the filter housing and
push the retainer into position.
N Refit the filter cover and turn the
filter cover lock to the horizontal
position
Exhaust emissions are controlled by the
design of the fundamental engine
parameters and components (e.g.
carburation, ignition, timing and valve or
port timing) without the addition of any
major hardware.
The carburetor comes from the factory
with a standard setting.
This setting provides an optimum fuel-air
mixture under most operating
conditions.
With this carburetor it is only possible to
adjust the high speed screw (H) and low
speed screw (L) within fine limits.
Preparations
N Stopping the engine
N Check the air filter and clean or
replace if necessary.
N Check that the throttle cable is
properly adjusted – readjust if
necessary – see chapter on
"Adjusting the Throttle Cable".
N Check the spark arresting screen
(not in all models, country-specific)
in the muffler and clean or replace if
necessary.
Engine Management Adjusting the Carburetor