Instruction Manual

BR 200
English
7
Vibration behavior is influenced by the
condition of the AV elements – check the
AV elements at regular intervals.
Shut off the engine before rectifying
problems.
Maintenance, replacement, or repair of
the emission control devices and
systems may be performed by any
nonroad engine repair establishment or
individual. However, if you make a
warranty claim for a component which
has not been serviced or maintained
properly or if nonapproved replacement
parts were used, STIHL may deny
coverage.
For any maintenance please refer to the
maintenance chart and to the warranty
statement near the end of the instruction
manual.
A screwdriver is included in the
accessory bag provided.
Fitting the pleated hose on the elbow
N Open the hose clamp (1) and fit it on
the pleated hose (2).
N Engage the tab in the recess.
N Push the pleated hose (2) over the
slip ring (3) as far as stop.
N Line up the hose clamp (1) and slip
ring (3) – as shown.
N Tighten down the screw (arrow).
Mounting the blower tube and nozzle
N Connect the blower tube (4) and
nozzle (5).
Assembling the Unit
1
2
9928BA001 AM
1
0000-GXX-2036-A0
3
2
0000-GXX-2037-A0
4 5
9928BA003 AM