Instruction Manual

BR 200
English
8
Mounting the Control Handle
N Pull the ends of the clamp on the
control handle (6) apart and push it
over stub of pleated hose (2).
N Attach throttle cable to retainer on
the hose clamp (1).
Adjusting the Control Handle
N Put the machine on your back and
adjust the harness – see "Fitting the
Harness".
N Push the blower tube (4) into the
stub of pleated hose (2) as far as
the stop.
N Move the control handle (6) along
the tube to the most comfortable
position.
N Tighten down the screw on the
control handle (6).
It may be necessary to correct the
adjustment of the throttle cable after
assembling the machine or after a
prolonged period of operation.
Adjust the throttle cable only when the
unit is completely and properly
assembled.
N Set throttle trigger to the full throttle
position – as far as stop.
N Carefully rotate the screw in the
throttle trigger in the direction of the
arrow until you feel initial resistance.
Then rotate it another full turn.
Adjusting the Harness
N Pull the ends of the straps
downwards to tighten the harness.
Loosening the Harness
N Lift the tabs of the sliding adjusters.
N Adjust the harness so that the
backplate fits snugly and securely
against your back.
1
6
2
9928BA004 AM
2 4
6
9928BA005 AM
Adjusting the Throttle Cable
0009BA008 KN
Fitting the Harness
373BA003 KN
373BA004 KN