Instruction Manual

BR 350
English
8
N Push the pleated hose (4) over the
slip ring (2) as far as stop.
N Position the hose clamp (3) as
shown in the illustration.
N Tighten down the screw (arrow).
Mounting the blower tubes and nozzle
N Assemble the blower tubes (5) and
nozzle (6).
Mounting the control handle
N Pull the ends of the clamp on the
control handle (7) apart and push it
over stub of pleated hose (4).
N Attach throttle cable to retainer on
the hose clamp (3).
Adjusting the Control Handle
N Put the machine on your back and
adjust the harness – see "Fitting the
Harness".
N Push the blower tube (5) into the
stub of pleated hose (4) as far as
the stop.
N Move the control handle (7) along
the tube to the most comfortable
position.
N Tighten down the screw on the
control handle (7).
It may be necessary to correct the
adjustment of the throttle cable after
assembling the machine or after a
prolonged period of operation.
Adjust the throttle cable only when the
unit is completely and properly
assembled.
N Set throttle trigger to the full throttle
position – as far as stop.
N Carefully rotate the screw in the
throttle trigger in the direction of the
arrow until you feel initial resistance.
Then rotate it another full turn.
3
0000-GXX-2039-A0
2
4
0000-GXX-2040-A0
0009BA005 KN
6
5
5
3
0009BA006 KN
7
0009BA007 KN
5
7
Adjusting the Throttle Cable
0009BA008 KN