Instruction Manual

BR 350
English
11
NOTICE
With the engine stopped and before
starting, check the air intakes between
the backplate and powerhead for
blockages and clean if necessary.
Functions of setting lever
The power tool is equipped with different
types of control handle.
Run position F
Engine runs or is ready to start. Throttle
trigger (2) can be moved to any position.
Switch off engine †
Ignition is interrupted, engine stops. The
setting lever (1) is not locked in this
position. It springs back to the run
position F. The ignition is again ready for
operation.
Fixed throttle
The throttle trigger (2) can be locked in
any position:
To disengage the lock:
N Return the setting lever (1) to the
run position F.
Run position F
Engine runs or is ready to start. Throttle
trigger (2) can be moved to any position.
Switch off engine †
Ignition is interrupted, engine stops. The
setting lever (1) is not locked in this
position. It springs back to the run
position F. The ignition is again ready for
operation.
Lock position C
The throttle trigger (2) can be locked in
three positions: 1/3 throttle, 2/3 throttle
and full throttle. To disengage the lock,
move the setting lever (1) back to the
normal run position F.
Starting the Engine
N Observe safety precautions.
NOTICE
Start your unit on a clean, dust-free
surface only to ensure that no dust is
sucked in.
N The setting lever must be on F
Information Before You Start
2
1
0009BA009 KN
2
1
0009BA010 KN
452BA122 KN
1
2
Starting / Stopping the
Engine
0009BA011 KN
0009BA021 KN