Owner's Manual

12
English / USA
BR 340, BR 380
Mounting the Elbow
A combination wrench and carburetor
screwdriver are stowed on the underside
of the blower.
The throttle cable is already
connected. Make sure it is not
kinked during assembly.
: Push the elbow (1) into the stub (2)
as far as it will go – the stops on the
elbow and stub must line up.
: Fit the nut (3) in the hexagon recess
in the stub.
: Insert the screw in the nut from the
other side and tighten moderately –
the elbow must still turn freely.
: Secure the throttle cable (4) in
position with the retainer (5).
Mounting the Blower Tubes
Operate the machine only with
both blower tubes properly
mounted.
: Push the blower tube (6) into the
pleated hose (7).
: Push blower tube (8) onto the end of
blower tube (6) and rotate it
clockwise until the bayonet coupling
locks.
: Push the nozzle (9) onto the blower
tube (8) and rotate it clockwise until
the bayonet coupling locks.
: Rotate the pleated hose (7)
counterclockwise as far as stop and
leave it in that position.
: Turn the control handle (10)
counterclockwise to the horizontal
position.
: Rotate the complete blower tube
assembly until the nozzle discharge
opening points in the same direction
as the control handle.
: Tighten down the clamp screw (11).
Assembling the Blower
353BA002 KN
2
3
1
373BA001 KN
8
7
4
9
10
6
11
5