Owner's Manual

Tools are stowed on the underside of
the blower (one combination wrench and
one carburetor screwdriver)
0RXQWLQJWKHHOERZ
•
Line up the stops on the elbow 
and fan housing stub .
•
Push the elbow  into the stub 
as far as it will go
•
Fit the nut  into the hexagon
recess on the stub.
•
Insert the screw in the nut from the
other side and tighten moderately -
the elbow must still turn.
Important: The throttle cable is already
connected and must not be kinked
during assembly.
•
Secure throttle cable  to the
pleated hose with the retainer .
0RXQWLQJWKHEORZHUWXEH
•
Push the blower tube  into the
pleated hose .
•
Push blower tube  onto the end
of tube  and rotate it clockwise to
engage the bayonet coupling.
•
Push the nozzle  onto the end
of blower tube  and rotate it
clockwise to engage the bayonet
coupling.
•
Rotate the pleated hose  counter-
clockwise as far as the stop and
leave it in that position.
•
Turn the control handle  to the
horizontal position.
•
Now rotate the complete blower
tube until the nozzle points in the
same direction as the control
handle.
•
Tighten down the clamp screw .
$VVHPEOLQJWKH%ORZHU
353BA002
2
3
1
353BA003
8
7
4
9
10
6
11
5
 %5