Instruction Manual

BR 350, BR 430
English
14
N Engage the throttle cable (4) with
sleeve (5) in the retainer (6).
Wear mark on nozzle
The front end of the nozzle wears away
due to abrasive ground contact during
operation. The nozzle is subject to
normal wear and tear and must be
replaced when the wear mark is
reached.
Fitting the transport aid
When storing or transporting the
machine:
N Secure the hook and loop fastener
to the blower tube – pull the flap
through the buckle.
N Secure the blower tube to the
handle on the backplate.
It may be necessary to correct the
adjustment of the throttle cable after
assembling the machine or after a
prolonged period of operation.
Adjust the throttle cable only when the
unit is completely and properly
assembled.
N Set throttle trigger to the full throttle
position – as far as stop.
N Carefully rotate the screw in the
throttle trigger in the direction of the
arrow until you feel initial resistance.
Then rotate it another full turn.
452BA100 KN
Adjusting the Throttle Cable
0009BA008 KN