Instruction Manual

BR 350, BR 430
English
16
N Press the cap down with your hand
as far as possible, turn it
counterclockwise (approx. 1/8 turn)
and remove it.
Fueling
Take care not to spill fuel while fueling
and do not overfill the tank.
Close the bayonet fuel filler cap
N Fit the cap and turn it until it
engages in the bayonet mount.
N Press the cap down with your hand
as far as possible and turn it
clockwise (approx. 1/8 turn) until it
engages completely.
Opening the threaded filler cap
N Turn the cap counterclockwise until
it can be removed from the tank
opening.
N Remove the filler cap.
Refueling
Take care not to spill fuel while fueling
and do not overfill the tank.
Closing the threaded filler cap
N Position cap.
N Turn the cap clockwise as far as it
will go and tighten it as securely as
possible by hand.
NOTICE
With the engine stopped and before
starting, check the air intakes between
the backplate and powerhead for
blockages and clean if necessary.
Positions of setting lever – BR 350
Run position F
Engine runs or is ready to start. Throttle
trigger (2) can be moved to any position.
Switch off engine †
Ignition is interrupted, engine stops. The
setting lever (1) is not locked in this
position. It springs back to the run
position F. The ignition is switched on
again.
0002BA014 KN
2.
1.
0002BA015 KN
2.
1.
002BA447 KN
002BA448 KN
Information Before You Start
2
1
0009BA009 KN