Owner's Manual

BR 350, BR 430
English
15
Preparations
Before fueling, clean the fuel filler cap
and the area around it so that dirt cannot
fall into the tank.
Thoroughly shake up the mixture in the
canister before fueling your machine.
Do not spill any fuel and do not fill the
tank up to the brim.
Open the fuel filler cap
N Press the cap down with your hand
as far as possible, turn it
counterclockwise (approx. 1/8 turn)
and remove it.
Fueling
Take care not to spill fuel while fueling
and do not overfill the tank.
Close the fuel filler cap
N Fit the cap and turn it until it
engages in the bayonet mount.
N Press the cap down with your hand
as far as possible and turn it
clockwise (approx. 1/8 turn) until it
engages completely.
Positions of setting lever – BR 350
Run position F
Engine runs or is ready to start. Throttle
trigger (2) can be moved to any position.
Switch off engine †
Ignition is interrupted, engine stops. The
setting lever (1) is not locked in this
position. It springs back to the run
position F. The ignition is switched on
again.
Fueling
To avoid the risk of burns or other
injuries due to escaping gasoline
vapors, open the fuel filler cap
carefully so that any excess
pressure in the tank can escape
slowly.
Never use a tool to open the
bayonet catch. This could damage
the cap and cause fuel to leak out.
0002BA014 KN
2.
1.
0002BA015 KN
2.
1.
Information Before You
Start
With the engine stopped and
before starting, check the air
intakes between the backplate
and powerhead for blockages and
clean if necessary.
2
1
0009BA009 KN