Owner's Manual

BR 350, BR 430
English
23
N Carefully remove the rope rotor with
washer (4) and pawls (5).
N Use a screwdriver to pry the rope
out of the starter grip.
N Remove the remaining rope from
the rotor and starter grip.
N Thread the new rope through the
starter grip and tie one of the special
knots shown.
N Pull the knot back into the grip.
N Thread the end of the rope through
the top of the guide bushing (6) and
rope rotor (7) and secure it with a
simple overhand knot.
N Coat the rope rotor bearing bore
with non-resinous oil.
N Slip the rotor over the starter
post (8) – turn it back and forth to
engage the anchor loop of the
rewind spring.
N Refit the pawls (5) in the rotor.
N Fit the washer (4) on the starter
post.
N Use a screwdriver or suitable pliers
to install the spring clip (3) on starter
post and engage it on the pawls'
peg – the spring clip must point
counterclockwise as shown in the
illustration.
Tensioning the rewind spring
N Make a loop in the unwound starter
rope and use it to turn the rope rotor
six full revolutions in the direction of
the arrow.
N Hold the rotor steady.
N Pull out and straighten the twisted
rope.
213BA018 KN