Instruction Manual

BR 500, BR 550, BR 600
English
16
Stopping the Engine
N Push the setting lever in the
direction of † – the engine stops –
the setting lever then springs back
automatically.
If engine does not start
Choke knob
If you did not turn the choke knob to n
quickly enough after the engine began to
fire, the combustion chamber is flooded.
N Push the setting lever (1) upwards.
The throttle trigger (2) is in the full
throttle position.
N Move the setting lever (1) to C.
N Engage the throttle trigger (2) in the
full throttle position.
N Continue cranking until the engine
runs.
Other Hints on Starting
If the engine does not start
N Check that all settings are correct.
N Check that there is fuel in the tank
and refuel if necessary.
N Check that the spark plug boot is
properly connected.
N Repeat the starting procedure.
N Check adjustment of throttle cable –
see chapter on "Adjusting the
Throttle Cable".
Engine stalls in cold start position c or
under acceleration
N Move the choke knob to o and
continue cranking until the engine
runs.
Engine does not start in warm start
position o
N Move the choke knob to c and
continue cranking until the engine
runs.
Fuel tank run until completely dry
N After refueling, press the manual
fuel pump bulb at least five times –
even if the bulb is filled with fuel.
N Set the choke knob according to
engine temperature.
N Now start the engine.
0009BA018 KN
0009BA023 KN
2
1
0000-GXX-1401-A0
0000-GXX-1402-A0