Instruction Manual

BR 800
English
19
N Use resistor type spark plugs with a
properly tightened adapter nut.
Installing the Spark Plug
N Screw the spark plug (4) into the
cylinder and fit the boot (3) (press it
down firmly).
N Fit the cover (2).
N Insert and tighten down the
screw (1).
NOTICE
If the blower is operated without the
cover (2), the engine may overheat and
this can result in engine damage.
N Operate your blower only with the
cover fitted in position.
N If the engine is down on power,
check the spark arresting screen in
the muffler.
N Wait for the muffler to cool down.
N Loosen the screws (1).
N Remove the scoop (2).
N Remove the spark arresting screen
(3).
N Clean the spark arresting screen. If
the screen is damaged or heavily
carbonized, fit a new one.
N Refit the spark arresting screen (3).
N Fit the scoop.
For periods of about 3 months or longer
N Drain and clean the fuel tank in a
well ventilated area.
N Dispose of fuel properly in
accordance with local
environmental requirements.
N Run the engine until the carburetor
is dry – this helps prevent the
carburetor diaphragms sticking
together.
N Thoroughly clean the machine – pay
special attention to the cylinder fins
and air filter.
N Store the machine in a dry and safe
location. Keep out of the reach of
children and other unauthorized
persons.
Hanging the Blower on a Hook
The hole (arrow) in the backplate can be
used to hang up the blower.
3
4
2
1
0000-GXX-6234-A0
Spark Arresting Screen in
Muffler
2
1
452BA090 KN
1
0000-GXX-B529 -A0
3
Storing the Machine
0000-GXX-5387-A0