Instruction Manual

BT 130
English
14
N Switch off the motor and activate the
auger brake – see "Auger brake"
N Put down the auger – drilling spindle
facing upwards
N Pull the retaining pin (1) out of the
auger shaft
N Push the auger (2) onto the drilling
spindle until the holes (3) align
N Insert the retaining pin into the hole
N Fold down the spring clip of the
retaining pin so that it encloses the
auger shaft
Engaging the Auger Brake
N Move the activating lever to
position A .
Starting
N Press down the trigger lockout
lever (1), then squeeze the throttle
trigger (2)
N and hold them in that position.
N Move the slide control (3) to START
and hold it there.
N Now release the throttle trigger,
slide control and trigger lockout in
that order. This is the starting
throttle position.
Fitting the Auger
9912BA010 KN
1
2
3
3
Starting / Stopping the
Engine
9912BA008 KN
A
9912BA011 KN
START