Instruction Manual

BT 130
English
15
N Set the choke knob (4) to:
N Press the manual fuel pump
bulb (5) at least five times.
Cranking
N Place the unit on the ground so that
it is secure.
N Put your left foot on the handle
frame.
N Left hand on the handle frame.
N Pull the starter grip slowly with your
right hand until you feel it engage
and then give it a brisk strong pull.
NOTICE
Do not pull out the starter rope all the
way – it might otherwise break.
N Do not let the starter grip snap back.
Guide it slowly back into the housing
so that the starter rope can rewind
properly.
N Continue cranking.
When engine begins to fire
N Set the choke knob to e and
N continue cranking until the engine
runs.
As soon as the engine runs
N Blip the throttle trigger (2) – the slide
control (3) moves to the run
position F and the engine settles
down to idling speed.
NOTICE
Since the auger brake is still engaged,
the engine must be returned to idling
speed immediately – or the clutch might
otherwise be damaged.
g if the engine is cold
e for warm start – also use this posi
-
tion if the engine has been running
but is still cold.
4
5
9912BA012 KN
9912BA013 KN
9912BA014 KN