Instruction Manual

BT 45
English
8
N Open up the clamp slightly.
N Push the handle over the chuck until
it butts against the machine – the
clamp must engage the groove on
the gearbox housing.
N Screw the handle into clamp
clockwise.
N Move the handle to the required
position and tighten it down firmly.
Assist handle for planting hole auger
and ice auger
N Loosen the two wing screws (3) on
the flange (4).
N Make sure the polymer bushing is
properly seated (see arrow).
N Push the flange onto the machine
as far as stop and line it up.
N Insert the handle tube (5) in the
flange.
N Move the handle to the required
position and tighten down the two
wing screws firmly.
Your power drill can be used for a range
of applications, e.g. fence-building and
carpentry (kit for wood drill), in
landscaping and gardening (kit for
planting hole auger) and ice fishing (kit
for ice auger).
General
WARNING
To change the drilling tool, always shut
off the engine and set the rotary knob
to N.
Always fit the assist handle specified for
the drilling tool you intend to use. See
"Mounting the Handles".
WARNING
During operation, always hold the
machine firmly with both hands to
control unexpected reactive forces
caused by the drilling tool jamming in or
passing through the material.
421BA036 KN
421BA005 KN
421BA037 KN
3
4
3
5
421BA007 KN
Using the Unit