Instruction Manual

BT 45
English
14
N Fit filler cap and turn it
counterclockwise until it engages in
the seat of the filling port
N Continue to turn the filler cap
counterclockwise (approx. 1/4 turn)
– this will twist the base of the cap
into the correct position
N Turn the filler cap clockwise and
close it – see section "Closing"
The power drill is equipped with a
change-speed gearbox. Depending on
the application and the drilling tool used,
the speed can be adjusted to suit
requirements.
Knob positions
NOTICE
The position of the rotary knob may be
changed only when the engine is
running at idle speed – the drilling
spindle must be stationary. It may be
necessary to turn the drilling spindle
slightly before the rotary knob can be
moved to the required position.
WARNING
Do not change the position of the rotary
knob while the engine is running above
idle speed – the drilling tool rotates.
N Neutral: Gearbox in neutral for
starting, adjusting the carburetor
and changing the drilling tool.
1 Low-speed clockwise rotation, see
"Specifications"
2 High-speed clockwise rotation, see
"Specifications"
R Counterclockwise rotation, e.g. for
releasing a trapped drilling tool
left: Base of filler cap is twisted –
interior marking (1) is aligned
with the exterior marking
right: Base of filler cap is in the cor
-
rect position – interior
marking is below the bracket.
It does not align with the
exterior marking
1
001BA238 KN
001BA239 KN
Gearbox
421BA017 KN