Instruction Manual

BT 45
English
15
N With the engine stopped (knob in N
position), out the machine on the
ground and make sure it is secure.
Chuck for wood drills or twist drills
N Insert the drilling tool (1) in the
chuck (2) and tighten it firmly.
WARNING
!When using the geared rim drill chuck
(special accessory), make sure you
remove the chuck key before starting up.
Adapter for ice auger or planting hole
auger
N Screw the adapter (3) onto the
drilling spindle (4).
N Use a 13mm open-end wrench to
hold the spindle steady and tighten
the adapter firmly with a 19mm
open-end wrench.
N Secure the drilling tool (5) in the
adapter.
N Use a 17mm open-end wrench to
secure and release the planting
hole auger.
N Set rotary knob to N (gearbox in
neutral).
WARNING
The machine may only be started with
the gearbox in neutral. If left in positions
1, 2 and R, the drilling tool may begin to
rotate when the clutch engagement
speed is reached. This could result in
accidents or personal injury due to loss
of control.
Fitting the Auger
421BA018 KN
1
2
5
421BA019 KN
5
4
3
3
3
Starting / Stopping the
Engine
421BA020 KN