Instruction Manual

BT 45
English
16
Starting the Engine
N Depress the choke lever (1) and set
it to
N Move the stop switch (2) to F and
N squeeze the throttle trigger (3) and
hold it there.
N Press in the starting throttle lock (4)
and hold it there.
N Let go of the throttle trigger and
starting throttle lock. This is the
starting throttle position.
N Press the manual fuel pump
bulb (5) at least five times.
Cranking
N Place the unit on the ground so that
it is secure.
N Press the machine against the
ground with your left hand on the
engine housing.
N Pull the starter grip slowly with your
right hand until you feel it engage
and then give it a brisk strong pull.
Do not pull out the starter rope to full
length – it might otherwise break.
Do not let the starter grip snap back.
Guide it slowly back into the housing
so that the starter rope can rewind
properly.
When engine begins to fire
N Set choke lever to j and
N continue cranking.
As soon as the engine runs
N Blip the throttle trigger – the starting
throttle lock moves to the normal run
position and the engine returns to
idling speed.
Stopping the Engine
N Move the stop switch to 0.
l if the engine is cold
j for warm start – also use this posi
-
tion if the engine has been running
but is still cold.
4
1
421BA021 KN
2
3
421BA022 KN
5
421BA001 KN
421BA023 KN