Instruction Manual

BT 45
English
4
Carry the machine with the drilling tool
pointing down – keep the hot muffler
away from your body.
It is also possible to use a shoulder strap
(special accessory).
By vehicle: When transporting in a
vehicle, properly secure your machine to
prevent turnover, damage and fuel
spillage.
Refueling
Always shut off the engine before
refueling.
Do not fuel a hot engine – fuel may spill
and cause a fire.
Open the fuel cap carefully to allow any
pressure build-up in the tank to release
slowly and avoid fuel spillage.
Only refuel the machine in a well
ventilated place. If fuel has been spilled,
immediately clean the machine – do not
allow your clothes to be splashed with
fuel. If that happens, change your
clothes at once.
Before starting
Check that your power tool is properly
assembled and in good condition – refer
to appropriate chapters in the instruction
manual.
– Check the fuel system for leaks,
especially the visible parts, e. g.,
fuel cap, hose connections, manual
fuel pump (only in machines with a
manual fuel pump). In case of
leakage and damage, do not start
the engine – risk of fire! Have the
machine serviced by a dealer
before using it
– Slide control / stop switch must
move easily to STOP or 0
– Additional front assist handle
properly mounted to suit drilling tool
being used.
– Smooth action of throttle trigger and
starting throttle lock – throttle trigger
must return automatically to idle
position.
– Check that the spark plug boot is
secure – a loose boot may cause
arcing that could ignite combustible
fumes and cause a fire!
– Never attempt to modify the controls
or safety devices
– Keep the handles dry and clean –
free from oil and dirt – this is
important for safe control of the
machine
To reduce the risk of personal injury, do
not operate your power tool if it is
damaged or not properly assembled!
Starting the engine
Start the engine at least 3 meters from
the fueling spot, outdoors only.
Place the machine on a flat surface and
ensure a firm and safe footing, hold the
machine firmly. The auger must not
touch any objects or the ground because
it may begin to rotate when the machine
is started.
Gearbox in neutral – knob in N.position.
The machine is operated by a single
person only – do not allow any person to
stay within the working area – nor with
starting. To reduce the risk of injury,
avoid contact with the drilling tool.
Do not drop-start the engine – start it as
described in the User Manual.
Check idle speed setting: The drilling
tool must not rotate when the engine is
idling with the throttle trigger released.
Keep easily combustible materials (e.g.,
wood chips, bark, dry grass, fuel) away
from hot exhaust gases and the hot
muffler surface – risk of fire!
Gasoline is highly flam
-
mable – keep away from
fire or flame – do not spill
any fuel – no smoking.
Place the clip lock fuel
cap (bayonet-type) in
position, turn it until it will
go no further and fold the
clip lock down.
Check for fuel leakage
while refueling and during
operation. Never start the
engine if fuel has been
spilled or is leaking –
Fatal burns may result!