Owner's Manual

14
English / USA
FCS
Connecting attachment to basic
power tool
: Loosen the clamp screws on the
gearbox housing of the power tool
and pull the gearbox off the drive
tube.
The drive shaft may slip out of the
tube when you pull off the gearbox.
If this happens push the drive shaft
back into the tube.
The drive shaft must not project from the
tube any more than L (22 mm or 7/8“).
If necessary, apply slight pressure to the
drive shaft and rotate it slowly at the
same time until it can be pushed in to the
required length.
Mounting the gearbox
: Loosen the clamp screws (1) on the
gearbox (2) and clamp (3).
: Push the drive tube (4) through the
clmp and into the gearbox, turning
the gearbox back and forth at the
same time.
: Once the end of the drive tube is
inserted beyond the slot in the
clamp (5), push the gearbox right up
to the stop.
: Fit the clamp screws as far as stop.
: Line up the gearbox (2) on the drive
tube so that the machine support (6)
on the powerhead and the tread of
the depth wheel (7) are horizontal.
: Tighten the clamp screws firmly.
Mounting the Gearbox
402BA001 KN
381BA015 KN
L
1
1
406BA001 KN
2
3
4
5
406BA002 KN
2
7
6
406BA003 KN
2