Owner's Manual

15FCS
English / USA
: Place the power edger on a
suitable support so that the blade
mounting (1) faces upwards.
: Insert stop pin or Allen wrench (2) –
see Special Accessories – as far as
possible in the bore (3) – push
lightly and rotate it back and forth
together with the thrust washer (4)
until the drive shaft is blocked.
: Apply combination wrench (5) to
screw (6).
: Loosen screw clockwise (left-hand
thread) and take it out.
: Remove retaining ring (7), plain
washer (8) and thrust washer (4).
: Position blade (9) on the thrust
plate (10).
Collar (see arrow) must engage
hole in blade!
: Fit thrust washer on the drive shaft
(11).
: Block the drive shaft.
Fitting the Cutting Blade
1
245BA010 KN
6
3
406BA005 KN
2
4
5
10
4
9
406BA014 KN
11
8
7
6
9