Owner's Manual

16
English / USA
FCS
: Fit the plain washer and retaining
ring on the screw (6).
: Insert the screw in the shaft and
tighten it down firmly
(counterclockwise).
A loop handle (1) may already be
mounted to the basic power tool.
Position of Loop Handle
: Fit the loop handle (1) on the drive
tube approx. 20 cm (8“) (A) forward
of the control handle (2).
: Make sure that any parts that are
already fitted, i.e. the sleeve (3) and
carrying ring (4), are between the
loop handle and control handle.
Mounting the Loop Handle
: Place the clamp (5) in the loop
handle (1) and fit handle in position
on the drive tube (6).
: Fit the clamp (7).
: Line up the holes.
: Fit washers (8) on the screws (9)
and insert screws through the holes.
: Screw on the square nuts (10) as far
as stop.
Mounting the Loop Handle
2
1
002BA184 KN
A
4
3
1
6
002BA157 KN
10
7
10
5
9
8
9
8