Instruction Manual

FH
English
9
N Loosen the clamp screws (arrows)
on the gearbox housing – do not
remove them.
N Pull the gearbox off the drive tube.
If the drive shaft slips out of the tube
when you pull off the gearbox:
N Push the drive shaft into the tube.
The drive shaft must not project from the
tube more than L = 22 mm (7/8 in).
If dimension (L) is not correct:
N Apply slight pressure to the drive
shaft and rotate it slowly at the same
time until it can be pushed in to the
specified length.
Mounting the Gearbox
N Loosen the clamp screws (10).
N Push the gearbox (11) onto the
drive tube (5), turn the gearbox (11)
back and forth as necessary.
Once the end of the drive tube is
inserted beyond the slot in the
clamp (12):
N Push the gearbox (11) fully home as
far as stop.
N Tighten down the clamp screws
moderately.
N Line up the gearbox (11) with the
powerhead.
N Tighten down the clamp screws
firmly.
228BA085 KN
SP 10
381BA015 KN
L
11
10
10
5
0000-GXX-1681-A0
11
12
0000-GXX-1682-A0