Instruction Manual

FH
English
10
Models with Loop Handle
N Loosen the screws on the loop
handle.
N Align the loop handle (2) and move
it to the most comfortable position.
Distance A must not be more than A =
20 cm.
N Tighten down the screws on the
loop handle.
Fitting the Carrying Ring
A carrying ring is necessary if the power
tool is to be used with a shoulder
strap/harness. Not all versions of basic
power tools are equipped with a carrying
ring.
The carrying ring is available as a
special accessory and is mounted as
described below.
N Mount the carrying ring (1) about
5 cm (A) forward of the control
handle (2).
N Push the carrying ring (1) over the
drive tube.
N Insert the M5 nut (3) in the hex
recess in the carrying ring.
N Fit the M5x14 screw (4).
N Line up the carrying ring.
N Tighten down the screw firmly.
Angle Adjuster - 145°
The angle of th cutter bar can be
adjusted upwards in 4 stages from 0°
(straight) to 55°, and downwards in 7
stages from 0° to 90° (right angle facing
down). There are therefore 12 possible
working positions.
WARNING
To reduce the risk of injury, carry out the
adjustment only when the cutting blades
are at a standstill – engine at idle speed.
WARNING
The gearbox gets hot during operation.
To reduce the risk of burn injury, do not
touch the gearbox.
2
A
0000-GXX-1680-A0
A
1
2
3
4
0000-GXX-1850-A0
Adjusting the Cutter Bar
0000-GXX-1683-A0
145°