Instruction Manual

FH
English
7
WARNING
This interchangeable attachment is only
approved for use on a basic power tool
equipped with one of the following
handle systems:
– Bike handle
– Loop handle
Operation of this interchangeable
attachment is permitted only with the
following basic power tools:
Bike-handled or loop-handled machines
– STIHLKA85R
– STIHL FS 91, FS 91 R, FS 111,
FS 111 R, FS 131, FS 131 R
WARNING
Combinations with basic power tools
other than those listed above are not
permitted since they may result in
accidents or serious personal injury.
To retrofit the loop handle see chapter
on "Mounting the Loop Handle".
To retrofit the carrying ring – see "Fitting
the Carrying Ring".
The FH attachment is not approved for
use on machines with a short drive tube.
Preparations for Mounting the
Attachment
WARNING
To reduce the risk of injury, always shut
off the engine before converting the
basic power tool.
NOTICE
Make sure the work area is clean before
mounting or removing the attachment.
N Rest the power tool on the machine
support.
Removing the Protective Cap
If a cap is fitted on the end of the power
tool's drive tube:
N Pull the protective cap off the end of
the drive tube and keep it in a safe
place.
Approved Basic Power Tools
002BA658 KN
Mounting the Attachment
413BA014 KN