Operation Manual

FS 310
English
19
N Hold the lower clamp (1) steady.
N Unscrew and remove the clamping
screw (2). The clamps are loose
once the clamping screw has been
removed.
N Remove the upper clamp (3) from
the lower clamp.
N Place the handlebar (4) in the lower
clamp (1) so that distance A is no
more than 6 in (15 cm).
N Place the upper clamp in position
and press it down.
N Insert the clamping screw.
N Line up the handlebar at a right
angle to the drive tube.
N Tighten down the clamping screw
firmly.
N Take out the screw (5), the nut (6)
remains in the control handle (7).
N Push the control handle onto the
end of the handlebar (4) until the
holes (9) line up – the throttle
trigger (8) must point towards the
gearbox.
N Insert the screw and tighten it down
firmly.
N Go to "Adjusting the Throttle Cable".
Transport and storage position: Loosen
the clamping screw, turn the handlebar
in line with the drive tube and fold the
handles down.
Mounting the Bike Handle
3
1
2
256BA001 KN
A
4
1
256BA002 KN
9
5
7
8
4
9
002BA256 KN
6
7