Operation Manual

FS 310
English
28
Closing the threaded filler cap
N Position cap.
N Turn the cap clockwise as far as it
will go and tighten it as securely as
possible by hand.
N Put on the full harness (1).
N Adjust the length of the strap so that
the spring hook (2) is about a hand’s
width below your right hip. Over-
long ends of straps may be
shortened after completing the
adjustment.
N Attach the spring hook to the
machine's perforated strip (3).
Find the right attachment point for the
cutting attachment you are using – see
"Balancing the Brushcutter".
The unit is balanced differently,
depending on the cutting attachment
used.
N With the unit suspended from the
harness, see how it is balanced and
change attachment point as
necessary:
Mowing attachments
Mowing heads, grass cutting blades and
brush knives should just touch the
ground.
Circular saw blades
Circular saw blades should "hover"
about 8 in. (20 cm) above the ground.
002BA448 KN
Fitting the Full Harness
2
3
1
002BA240 KN
Balancing the Machine
256BA016 KN
256BA017 KN