Operation Manual

FS 310
English
29
Controls
1 Throttle trigger lockout
2 Throttle trigger
3 Slide control
Positions of slide control
4STOP-0 – engine off – the ignition is
switched off
5 F – normal run position – the engine
is running or can start
6START – ignition is switched on –
the engine can start
Symbol on slide control
7 h – stop symbol and arrow. To stop
the engine, push the slide control in
the direction of the arrow on the stop
symbol (h) to STOP-0.
Starting
N Press down the trigger lockout lever
and squeeze the throttle trigger
N and hold them in that position.
N Move the slide control to START
and hold it there.
N Now release the throttle trigger,
slide control and trigger interlock in
that order. This is the starting
throttle position.
N Set the choke knob (8):
N Press the manual fuel pump
bulb (9) at least five times – even if
the bulb is already filled with fuel.
N Put the unit on the ground: It must
rest on the engine support and
deflector. Check that the cutting
attachment is not touching the
ground or any other obstacles.
N Make sure you have a firm footing.
N Hold the unit with your left hand and
press it down firmly – your thumb
should be under the fan housing.
NOTICE
Do not stand or kneel on the drive tube
since it will otherwise be permanently
bent and damaged.
Starting / Stopping the
Engine
3
STOP
56
4
7
002BA182 KN
1
2
START
STOP-
g if the engine is cold
e for warm start – also use this posi-
tion if the engine has been running
but is still cold.
249BA057 KN
9
8
273BA001 KN
273BA002 KN