Instruction Manual

20
English / USA
FS 45, FS 46
STIHL Polycut 6-3
: Fit the thrust plate on the shaft.
: Insert mounting nut (10) in the
mowing head.
: Screw mowing head (11) clockwise
onto the shaft (5) as far as stop.
: Block the output shaft with the stop
pin.
: Tighten down the mowing head.
Remove the tool used to block the
shaft.
Blocking the shaft
: Block the shaft by pushing the stop
pin (12) through the holes (13) in the
deflector and thrust plate – turn the
thrust plate back and forth if
necessary.
: Tighten down the mowing head
firmly.
Remove the tool used to block the
shaft.
STIHL FixCut 5-2
: Fit the thrust plate (2) on the shaft.
: Place the mowing head on the
thrust plate (2).
Collar (arrow) must locate in the
mowing head’s mounting hole.
: Push the thrust washer (3) over the
shaft (1) so that it locates against
the base.
: Block the output shaft.
: Use the combination wrench (5) to
screw the mounting nut (4)
counterclockwise onto the output
shaft and it tighten down firmly.
Remove the tool used to block the
shaft.
11
5
681BA019 KN
10
3
1
2
4
232BA074 KN
5