Instruction Manual

FS 56, FS 56 R, FS 56 C, FS 56 RC
English
20
N Place the clamp (7) in the loop
handle (4) and position them both
against the drive tube (8).
N Position the clamp (8) against the
drive tube.
N Place the barrier bar (6) in position
as shown.
N Line up the holes.
N Insert the screws (1) in the holes
and screw them into the barrier bar
as far as stop.
N Go to "Adjusting and Securing the
Loop Handle".
Leave the barrier bar permanently
mounted to the loop handle.
Adjusting and Securing the Loop Handle
The loop handle can be adjusted to suit
the height and reach of the operator and
the application by changing
distance (A).
Recommendation: distance (A):
about 15 cm (5.9 in)
N Slide the handle to the required
position.
N Line up the loop handle (4).
N Tighten down the screws until the
loop handle can no longer be
rotated on the drive tube. If no
barrier bar is fitted – lock the nuts if
necessary.
Polymer Version
The carrying ring comes standard with
the machine or is available as a special
accessory.
For position of carrying ring see "Main
Parts".
N Hold the carrying ring (1) with its
slotted side against the drive tube
and then push it over the drive tube.
N Insert the M5 nut in the hex recess
in the carrying ring.
N Fit the M5x14 screw from the other
side.
N Line up the carrying ring.
N Tighten down the screw firmly.
8
6
4
002BA610 KN
7
9
1
1
4
002BA611 KN
A
Fitting the Carrying Ring
A
B
A
B
1
002BA529 AS