Owner's Manual

FS 510 C-M, FS 560 C-M
English
26
N Place the cutting attachment (1) in
position.
Collar (a) must locate in the cutting
attachment's mounting hole (b).
N Fit the 2.4-in (60-mm) diameter
thrust washer (2) – convex side
must face up.
N Fit the 3.2-in (80-mm) diameter rider
plate (3).
N Block the drive shaft.
N Screw on the nut (4)
counterclockwise and tighten it
down firmly.
Removing the cutting attachment
N Block the drive shaft.
N Unscrew the mounting nut (4)
clockwise.
N Pull the cutting attachment with its
mounting hardware off the gearbox.
Mounting Brush Knives
N Check that the deflector on the
machine is approved for brush
knives – if not, perform the next two
steps.
N Remove grass shield with thrust
plate – if fitted.
N Remove the non-approved
deflector.
N Mount deflector for grass cutting
blades and brush knives.
N Use the 2.6-in (65-mm) diameter
thrust plate.
Cutting edges of brush knives 350-3
may point in either direction – these
cutting attachments must be turned over
regularly to help avoid one-sided wear.
N Place the cutting attachment (1) in
position.
Collar (a) must locate in the cutting
attachment's mounting hole (b).
N Fit the 2.8-in (70-mm) diameter
thrust washer (2) – convex side
must face up.
N Fit the guard ring (3) for brush
knives – opening must face up.
N Block the drive shaft.
N Screw on the nut (4)
counterclockwise and tighten it
down firmly.
a
b
1
3
2
4
002BA510 KN
681BA195 KN
1
002BA511 KN
3
4
2
b
a
3