Owner's Manual

FS 510 C-M, FS 560 C-M
English
40
N If the rewind spring needs to be
replaced, continue with "Replacing
the Rewind Spring".
N If the starter rope needs to be
replaced, continue with the
following chapter-
Replacing the Starter Rope
N Pry the cap out of the starter grip.
N Remove worn rope or remaining
rope from the rotor and starter grip.
N Thread the new rope through the
starter grip and tie a simple
overhand knot in its end as shown.
N Pull the knot back into the grip.
N Refit the cap in the grip.
N Thread the rope through the top of
the guide bushing (10) and rope
rotor (9).
N Tie a simple overhand knot in the
end of the rope.
N Pull the knot into the rope rotor – if
necessary, push the knot into the
rotor's recess.
N Go to "Installing the Rope Rotor".
Replacing the Rewind Spring
The bits of the spring may still be under
tension and could fly apart when you
remove the rope rotor and spring
housing. To reduce the risk of injury,
wear face protection and work gloves.
N Take out the screws (11).
N Remove the spring housing and
spring or bits of the spring.
N Lubricate the new, ready-to-fit
replacement spring in the new
spring housing with a few drops of
resin-free oil.
N Fit the replacement spring with
spring housing – the bottom plate
must face up.
If the spring pops out of the housing
during installation: Wear face protection
and work gloves and refit the spring in
the spring housing – clockwise – from
the outside inwards.
N Fit the screws.
3BA020 KN
3BA038 KN
10
9926BA043 KN
9
3BA022 KN
11
9926BA044 KN
11