Instruction Manual

FS 70 C, FS 70 RC
English
12
Approved combinations
Select the correct combination from the
table according to the cutting
attachment you intend to use.
WARNING
For safety reasons only the versions of
cutting attachments, deflectors, handles
and harnesses shown in each row of the
table may be used together. No other
combinations are permitted because of
the risk of accidents.
Cutting attachments
Mowing heads
1 STIHL SuperCut 20-2
2 STIHL AutoCut C 25-2
3 STIHL AutoCut 25-2
4 STIHL AutoCut C 26-2
5 STIHL FixCut 31-2
6 STIHL TrimCut 31-2
7 STIHL DuroCut 20-2
8 STIHL PolyCut 20-3
Metal cutting attachments
9 Grass cutting blade 230-2
(230 mm dia.)
10 Grass cutting blade 230-4
(230 mm dia.)
11 Grass cutting blade 230-8
(230 mm dia.)
WARNING
Non-metal grass cutting blades are not
approved.
Deflectors
12 Deflector with blade, for mowing
heads
13 Deflector for metal cutting
attachments
Handles
14 Loop handle
15 Loop handle with
16 barrier bar
17 Bike handle
Harness straps
18 Shoulder strap may be used
19 Shoulder strap must be used
20 Full harness may be used
Mounting the Handlebar
Mount the handlebar on the drive tube
about 10 cm (4 in) forward of the engine
housing.
N Place the handle support (1) on the
drive tube (2).
N Place the handlebar (3) in the
handle support.
N Fit the clamp (4) on the handle
support. Insert the screws (5)
through the holes in the parts and
screw them into clamp (6) as far as
stop – tighten them only moderately
at this stage.
Mounting the Bike Handle
4
5
1
6
3
2
002BA274 KN