Instruction Manual

FS 70 R
English
26
As soon as the engine runs
N Press down the throttle trigger
lockout and open the throttle – the
choke knob moves to the run
position F. After a cold start, warm
up the engine by opening the
throttle several times.
WARNING
Make sure the carburetor is correctly
adjusted. The cutting attachment must
not rotate when the engine is idling.
Your machine is now ready for
operation.
Stopping the Engine
N Move the stop switch in the direction
of 0 – the engine stops – release
the stop switch – it springs back to
the run position.
Other Hints on Starting
Engine stalls in cold start position g or
under acceleration
N Move the choke lever to < and
continue cranking until the engine
runs.
Engine does not start in warm start
position <
N Move the choke lever to g and
continue cranking until the engine
runs.
If the engine does not start
N Check that all settings are correct.
N Check that there is fuel in the tank
and refuel if necessary.
N Check that the spark plug boot is
properly connected.
N Repeat the starting procedure.
Fuel tank run until completely dry
N After refueling, press the manual
fuel pump bulb (P) at least
five times – even if the bulb is filled
with fuel.
N Set the choke lever to suit the
engine temperature.
N Now start the engine.
Using transport guard
Transport guards are available as
special accessories.
The transport guard can be used for
grass cutting blades up to a diameter of
230 mm.
Fitting the transport guard
0414BA014 KN
Transporting the Unit
681BA268 KN
681BA269 KN
681BA272 KN