Owner's Manual

FS 90, FS 90 R
English
32
Full harness
N Put on the full harness (1).
N Adjust the length of the strap so that
the spring hook (2) is about a hand’s
width below your right hip.
N Balance the trimmer/brushcutter.
Connect machine to harness
The type and version of the harness and
snap hook depend on the market.
N Hook the snap hook (1) into the
carrying ring (2) on the shaft
N Undo the screw (3)
Balance the machine
The machine will balance differently
depending on the cutting attachment
mounted.
Until the conditions listed under
"Hanging positions" are met, carry out
the following steps:
N Move carrying ring
N Tighten screw lightly
N Let the machine swing until it stops
moving
N Check hanging position
Balancing the
Trimmer/Brushcutter