Instruction Manual

6 Mounting the Loop Handle
6.1 Mounting Loop Handle with
Barrier Bar
2
002BA098 KN
1
1
► Fit the square nuts (1) in the barrier bar (2);
the holes must line up.
5
4
002BA099 KN
2
3
6
7
► Place the clamp (3) in the loop handle (4) and
position them both against the drive tube (5).
► Position the clamp (6) against the drive tube.
► Place the barrier bar (2) in position as shown.
► Line up the holes.
► Insert the screws (7) in the holes and screw
them into the barrier bar (2) as far as stop.
► Go to "Securing the Loop Handle".
6.2 Mounting the Loop Handle
without Barrier Bar
7
8
5
4
1
6
1
3
8
7
002BA614 KN
► Place the clamp (3) in the loop handle (4) and
position them both against the drive tube (5).
► Position the clamp (6) against the drive tube.
► Line up the holes.
► Fit washers (8) on the screws (7) and insert
the screws in the holes. Fit the square nuts (1)
and screw them down as far as stop.
► Go to "Securing the Loop Handle".
English 6 Mounting the Loop Handle
16 0458-426-8321-B