Instruction Manual

6.3 Securing the Loop Handle
9
4
A
002BA615 KN
The loop handle can be adjusted to suit the
height and reach of the operator and the applica‐
tion by changing distance (A).
Recommendation: distance (A): about 20 cm
(8 in)
► Slide the handle to the required position.
► Line up the loop handle (4).
► Tighten down the screws until the loop handle
can no longer be rotated on the drive tube. If
no barrier bar is fitted – lock the nuts if neces‐
sary.
The sleeve (9) (not fitted on all models) must be
between the loop handle and the control handle.
7 Adjusting the Throttle
Cable
It may be necessary to correct the adjustment of
the throttle cable after assembling the machine
or after a prolonged period of operation.
Adjust the throttle cable only when the unit is
completely and properly assembled.
002BA655 KN
► Set the throttle trigger to the full throttle posi‐
tion.
► Carefully rotate the screw in the throttle trigger
in the direction of the arrow until you feel initial
resistance. Then rotate it another half turn in
the same direction.
8 Fitting the Carrying Ring
8.1 Polymer Version
1
002BA529 KN
For position of carrying ring see "Main Parts".
► Push the carrying ring (1) over the drive tube.
► Insert the M5 nut in the hex recess in the car‐
rying ring.
► Fit the M5x14 screw.
► Line up the carrying ring.
► Tighten down the screw firmly.
7 Adjusting the Throttle Cable English
0458-426-8321-B 17