Owner's Manual

STIHL FS 94 R
English
20
Depending on the cutting attachment, it
may be necessary to use the nut (3),
rider plate (4) and thrust washer (5).
These parts are included in a kit
supplied with the machine and are also
available as special accessories.
Blocking the Shaft
The output shaft (2) must be blocked
with the stop pin (7) to mount or remove
cutting attachments. The stop pin is
included with the machine and is
available as a special accessory.
N Insert the stop pin (7) in the bore (8)
in the gearhead as far as stop, apply
slight pressure.
N Rotate shaft or cutting attachment
until the stop pin slips into position
and blocks the shaft.
Mounting the Cutting Attachment
WARNING
Use a deflector that matches the cutting
attachment – see "Mounting the
Deflector".
N Go to "Mounting the Mowing Head"
or "Mounting the Metal Cutting
Attachment".
Mounting the Mowing Head
Keep the instruction leaflet for the
mowing head in a safe place.
STIHL SuperCut 20-2
STIHL AutoCut 25-2,
STIHL TrimCut 31-2,
STIHL DuroCut 20-2,
STIHL FixCut 25-2,
STIHL FixCut 30-2,
STIHL PolyCut 20-3
N Screw the mowing head
counterclockwise on to the shaft (1)
as far as stop.
N Block the shaft.
N Tighten down the mowing head
firmly.
NOTICE
Remove the tool used to block the shaft.
Removing the Mowing Head
N Block the shaft.
STIHL SuperCut 20-2
STIHL AutoCut 25-2,
STIHL TrimCut 31-2,
STIHL DuroCut 20-2,
002BA267 KN
3
4
5
7
8
2
002BA384 KN
7
1
002BA385 KN