Owner's Manual

STIHL FS 94 R
English
21
STIHL FixCut 25-2,
STIHL FixCut 30-2,
STIHL PolyCut 20-3
N Unscrew the mowing head
clockwise.
Mounting Metal Cutting Attachments
WARNING
Wear protective gloves to reduce the
risk of direct contact with the sharp
cutting edges.
The nut (1), rider plate (2) and thrust
washer (3) are required to mount a
grass cutting blade. The parts are
available as special accessories.
Check direction of rotation of cutting
attachment
The skirt and line limiting blade are not
required on the deflector for grass
cutting blades 230-4 (1) and 230-8(2) or
the brush knife (3) – see "Mounting the
Deflector".
Lay your trimmer on its back with the
cutting attachment mounting face
pointing up: The cutting edges of (1)
may point in either direction. The cutting
edges of (2) must point clockwise.
Cutting edges of grass cutting blade (2)
must point clockwise.
Direction of rotation is indicated by an
arrow on the inside of the deflector.
N Place the cutting attachment (1) on
the thrust plate (2).
WARNING
Collar (see arrow) must engage the
cutting attachment's mounting hole.
Securing the cutting attachment
N Fit the thrust washer (3) and rider
plate (4) on the shaft (5).
N Use the combination wrench (7) to
screw the mounting nut (6) on to the
output shaft counterclockwise and
tighten it down firmly.
NOTICE
Remove the tool used to block the shaft.
WARNING
If the mounting nut turns too freely, fit a
new one.
002BA347 KN
1
2
3
1
2
681BA108 KN
3
1
2
4
5
6
7
681BA211 KN