Operators Manual
Table Of Contents
- Contents
- 1. Introduction
- 2. Safety Precautions
- 3. Specifications
- 4. Troubleshooting
- 5. Engine
- 6. Rewind Starter
- 7. Control Levers
- 8. Fuel System
- 8.1 Air Filter
- 8.2 Removing and Installing the Carburetor
- 8.3 Leakage Test
- 8.4 Servicing the Carburetor
- 8.5 Adjusting the Carburetor
- 8.6 Removing and Installing Throttle Cable (Loop Handle)
- 8.7 Removing and Installing the Spacer Flange
- 8.8 Tank Vent
- 8.9 Fuel Intake
- 8.10 Removing and Installing the Engine Housing
- 9. Drive Tube
- 10. Special Servicing Tools
- 11. Servicing Aids
53Series 4144 Components FC, FS, KM
: Inspect the tip (arrow) for
damage or wear and replace the
screw (L) if necessary.
– Screw down the low speed
screw (L) as far as stop.
– Continue with high speed screw.
High speed screw
: Use special tool 5910 890 4501
to pry the limiter cap (1) off the
high speed screw.
Do not re-install used cap – always
fit a new cap.
296RA263 TG
545RA015 TG
1
: Take out the high speed
screw (1).
: Inspect the tip (arrow) for
damage or wear and replace the
high speed screw if necessary.
– Screw down the high speed
screw (H) as far as stop.
545RA016 TG
1
296RA267 TG
Pre-installing limiter caps
Low speed screw (L)
Always use a new limiter cap and
position it so that the long part of the
cap butts against the underside of
the stop (arrow).
: Push the limiter cap (1) on to the
low speed screw as far as the first
detent – the limiter cap is thus
prepared for final installation.
296RA264 TG
1