Operators Manual
Table Of Contents
- Contents
- 1. Introduction
- 2. Safety Precautions
- 3. Specifications
- 4. Troubleshooting
- 5. Engine
- 6. Rewind Starter
- 7. Control Levers
- 8. Fuel System
- 8.1 Air Filter
- 8.2 Removing and Installing the Carburetor
- 8.3 Leakage Test
- 8.4 Servicing the Carburetor
- 8.5 Adjusting the Carburetor
- 8.6 Removing and Installing Throttle Cable (Loop Handle)
- 8.7 Removing and Installing the Spacer Flange
- 8.8 Tank Vent
- 8.9 Fuel Intake
- 8.10 Removing and Installing the Engine Housing
- 9. Drive Tube
- 10. Special Servicing Tools
- 11. Servicing Aids
57Series 4144 Components FC, FS, KM
: Pull the throttle cable (1) out of
the guides (arrows).
– Remove the throttle trigger and
disconnect the throttle cable,
b 7.3.1
– Check the throttle cable and
replace if necessary.
– Fit throttle cable on throttle
trigger, b 8.6
: Push the throttle cable sleeve (1)
into the guide as far as stop.
The throttle cable sleeve must butt
against the stop (arrow).
545RA280 TG
1
545RA022 TG
545RA144 TG
1
– Position the throttle cable under
the tank vent hose (1).
: Fit the throttle cable retainer (2) in
its seat (arrow).
: Push the throttle cable (1) into the
guides in the engine housing
(arrows) as far as stop.
: Tighten down the screw (1)
firmly.
– Install the carburetor, b 8.2
545RA074 TG
1
2
545RA280 TG
1
545RA024 TG
1
– Turn the pin (1) until the slot is in
line with the throttle cable.
: Press down the throttle lever (2).
– Fit throttle cable (1) in the pin's
(2) slot.
: Turn the pin until the nipple is
properly seated (arrow).
– Check operation of throttle cable
and readjust if necessary,
b 8.6.2
– Reassemble all other parts in the
reverse sequence.
– Tightening torques, b 3.4
545RA042 TG
1
2
545RA043 TG
2
1