Operators Manual
Table Of Contents
- Contents
- 1. Introduction
- 2. Safety Precautions
- 3. Specifications
- 4. Troubleshooting
- 5. Engine
- 6. Rewind Starter
- 7. Control Levers
- 8. Fuel System
- 8.1 Air Filter
- 8.2 Removing and Installing the Carburetor
- 8.3 Leakage Test
- 8.4 Servicing the Carburetor
- 8.5 Adjusting the Carburetor
- 8.6 Removing and Installing Throttle Cable (Loop Handle)
- 8.7 Removing and Installing the Spacer Flange
- 8.8 Tank Vent
- 8.9 Fuel Intake
- 8.10 Removing and Installing the Engine Housing
- 9. Drive Tube
- 10. Special Servicing Tools
- 11. Servicing Aids
73Series 4144 Components FC, FS, KM
The engine end of the drive tube
has cross holes, this end is installed
in the machine.
– Line up the loop handle (1) so
that the star knob screw (arrow)
points towards the engine.
: Slide the loop handle (1) onto the
engine end of the drive tube.
– Install the drive tube, b 9.1
: Position the loop handle (1) at a
distance of
about 7 cm (a) in front of the
engine housing.
– Line up the loop handle (1) so
that it points away from the
throttle trigger.
– Tighten down the star knob
screw (2) firmly.
1
545RA260 TG
a
12
545RA261 TG
9.1.7 Loop Handle with
Barrier Bar
– Remove the drive tube, b 9.1
: Loosen the screw (1).
– Slip the loop handle (2) off the
drive tube.
– Take out the screw.
: Pull the clamp (1) out of the loop
handle (2).
1
2
545RA262 TG
2
545RA263 TG
1
– Take out the screw (arrow) and
washer.
: Remove the barrier bar (1).
– Check the individual parts and
replace if necessary.
– Reassemble in the reverse
sequence.
: Push the clamp (1) into the loop
handle (2).
– Insert the screw (1)
– do not tighten it down yet.
1
545RA264 TG
545RA287 TG
1
2